When a problem occurs in the power source circuit, the fail-safe function works to stop the power assist.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Return-to-normal Condition | Note |
|---|---|---|---|---|---|---|
| C1551 | IG Power Supply Voltage | When the PIG power supply voltage is normal, the IG power supply voltage is 18.5 V or higher | ·
Harness or connector ·
Rack and pinion power steering gear assembly |
EPS warning light: Comes on | The ECU judges the system has returned to normal | - |
If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the C71 rack and pinion power steering gear assembly connector.
| *a | Front view of wire harness connector
(to Rack and Pinion Power Steering Gear Assembly) |
- | - |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C71-4 (IG) - Body ground | Ignition switch ON | Below 18.5 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is output. | A |
| DTC is not output. | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING