Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › 2017.09–2021.02
RM33A0E _54 Brake _065369 PARKING BRAKE _0328504 ELECTRIC PARKING BRAKE SYSTEM J

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  Electric Parking Brake does not Operate  


WIRING DIAGRAM

C367817E02
0.688,1.354 1.771,1.531 1.083,0.177 10 false ECU-IG1 NO. 2 2.615,1.083 2.885,1.25 0.271,0.167 10 false 36 2.927,1.198 3.271,1.365 0.344,0.167 10 false IG1 2.927,1.875 3.271,2.042 0.344,0.167 10 false A34 2.917,2.052 4.469,2.427 1.552,0.375 10 false Skid Control ECU (Brake Actuator Assembly) 5.167,1.646 7.031,1.854 1.865,0.208 10 false Combination Meter Assembly 1.271,3.292 3.135,3.5 1.865,0.208 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

·

The electric parking brake may still operate up to 20 seconds after the ignition switch is turned off. Before disconnecting connectors or fuses, turn the ignition switch off and wait 20 seconds or more.

·

When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch assembly as the parking brake indicator light blinks (red) when the ignition switch is first turned ON.



HINT:

Even if the electric parking brake is operating normally, the parking brake indicator light (red) on the combination meter may be malfunctioning.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.VEHICLE OPERATION CHECK

B

2.VEHICLE OPERATION CHECK
a.

When the vehicle's tires are lifted off the ground and the GTS is used to operate the electric parking brake, check the condition of the rear tires.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>ON-VEHICLE INSPECTION


Result:
Result Proceed to
Lock and release operation is normal and parking brake indicator light turns off or blinks (red) A
Lock and release operation is malfunctioning and parking brake indicator light illuminates (red) or turns off according to switch operation B
Lock and release operation is malfunctioning and parking brake indicator light turns off or blinks (red) C



A

3.PERFORM ACTIVE TEST USING GTS (PARKING BRAKE LIGHT)

B

INSPECT REAR BRAKE

C

5.CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY))
3.PERFORM ACTIVE TEST USING GTS (PARKING BRAKE LIGHT)
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / ABS/VSC/TRC/EPB / Data List.


f.

Read the Data List according to the display on the GTS.

Chassis > ABS/VSC/TRC > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
PKB Light Parking brake indicator light (red) ON or OFF
·

Vehicle stopped

·

Ignition switch ON


Chassis > ABS/VSC/TRC > Active Test
Tester Display
PKB Light
50004 105 113

g.

Select the Data List on the GTS.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Parking Brake Light Parking brake indicator light (red) output signal OFF, Light or Blink OFF: Parking brake indicator light (red) turns off
Light: Parking brake indicator light (red) illuminates
Blink: Parking brake indicator light (red) flashes
-
Chassis > ABS/VSC/TRC > Data List
Tester Display
Parking Brake Light
50003 105 479

h.

Check the operating condition of the parking brake indicator light (red) when operating it using the GTS.


Result:
Result Proceed to
The value of the Data List item does not change in accordance with the Active Test. A
The value of the Data List item changes in accordance with the Active Test. B



A

B

4.INSPECT COMBINATION METER ASSEMBLY
4.INSPECT COMBINATION METER ASSEMBLY
a.

Perform the Active Test of the combination meter assembly using the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display
Park Warning
50004 409 108

b.

Check the combination meter assembly.

OK:

Parking brake indicator light (red) turns on or off in accordance with GTS operation.



Result:
Proceed to
OK
NG



OK

NG

5.CHECK HARNESS AND CONNECTOR (BATTERY - SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY))
a.

Turn the ignition switch off.


b.
C360727C79
1.5,0.167 2,0.417 0.5,0.25 1.458,1 0.906,1.802 true 0.063,0.042 0.375,0.198 0.313,0.156 10 false *a 1.635,0.198 1.99,0.396 0.354,0.198 10 false A34 0.792,1.823 1.146,2.021 0.354,0.198 10 false IG1
*a Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly))


Disconnect the A34 skid control ECU (brake actuator assembly) connector.


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A34-36 (IG1) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR