Home › Engine / Hybrid System › CRUISE CONTROL › CAMERA HEATER › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0328546 CAMERA HEATER A

CRUISE CONTROL  CAMERA HEATER  INSTALLATION  


PROCEDURE

Hide 86461 1.INSTALL FORWARD RECOGNITION HOOD

NOTICE:
·

Do not apply force to the heater area as the heater may become damaged.

·

Do not forcibly pull the wire harness as it may become damaged.



a.
E365816C01
0,0 0,0 false
V100155

Heater Area
V113147

Install in this Direction (1)
V113148

Install in this Direction (2)


Engage the guide and claw as indicated by the arrows, in the order shown in the illustration.

NOTICE:

Make sure that the claw is engaged as shown in the illustration. Failure to do so may result in the malfunction of systems that use the forward recognition camera.



b.
E365814N02
2.823,0.313 2.979,0.51 0.156,0.198 10 true 7 2.177,0.292 2.333,0.49 0.156,0.198 10 true 6 1.677,0.688 1.833,0.885 0.156,0.198 10 true 5 2.146,0.917 2.302,1.115 0.156,0.198 10 true 4 2.146,1.167 2.302,1.365 0.156,0.198 10 true 3 2.271,1.531 2.427,1.729 0.156,0.198 10 true 2 1.5,1.729 1.656,1.927 0.156,0.198 10 true 1

Engage the 7 clamps to install the forward recognition hood.

NOTICE:

As the No. 1 forward recognition cover cannot be installed correctly if the clamps are not engaged securely, make sure to engage each clamp securely.


HINT:

Engage the clamps in the order shown in the illustration.



c.

Connect the connector.


Hide 8646C 2.INSTALL FORWARD RECOGNITION CAMERA