If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
88211B
1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
|
Bolt |
|
Screw |
Engage the 2 guides.
Tighten the 2 bolts and screw on the millimeter wave radar sensor assembly.
Tighten the bolts in the order shown in the illustration.
Connect the connector.
53295E
2.INSTALL COOL AIR INTAKE DUCT SEAL
3.ADJUST MILLIMETER WAVE RADAR SENSOR
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT