Home › Engine / Hybrid System › A25A-FKS (EMISSION CONTROL) › EGR COOLER › 2017.09–2020.08
RM33A0E _51 Engine / Hybrid System _065344 A25A-FKS EMISSION CONTROL _0328567 EGR COOLER A

A25A-FKS EMISSION CONTROL  EGR COOLER  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 25680 1.INSTALL EGR COOLER ASSEMBLY

a.
A402223C01
0.823,1.708 0.302,1.74 0.302,1.74 0.729,1.563 false 0.708,1.292 0.26,1.198 0.26,1.198 0.823,1.115 false 0.094,1.094 0.344,1.292 0.25,0.198 10 false *a 0.115,1.646 0.365,1.844 0.25,0.198 10 false *a
*a Claw


Install a new EGR cooler gasket to the EGR cooler assembly.

NOTICE:

Make sure that the claws of the EGR cooler gasket are toward the EGR cooler assembly side.



b.
A402224C01
1.042,0.802 1.271,1.094 true 2.042,0.563 1.865,0.833 true 1.375,1.406 1.729,1.76 1.729,1.76 1.917,1.115 true 0.865,0.677 1.063,0.896 0.198,0.219 10 true *a 2.042,0.438 2.281,0.646 0.24,0.208 10 true *a 1.667,1.823 1.906,2.031 0.24,0.208 10 true *a
*a Claw


Install a new EGR valve gasket to the EGR valve assembly.

NOTICE:

Make sure that the claws of the EGR valve gasket are toward the EGR valve assembly side.



c.
A402222N01
2.625,1.042 2.781,1.198 0.156,0.156 10 true A 1.792,1.969 1.938,2.125 0.146,0.156 10 true A 1.448,1.823 1.594,1.979 0.146,0.156 10 true A 0.354,1.052 0.49,1.208 0.135,0.156 10 true B 1.573,0.167 1.729,0.323 0.156,0.156 10 true B

Temporarily install the EGR cooler assembly to the cylinder head sub-assembly and EGR valve assembly with the 5 bolts.


d.

Tighten the 3 bolts (A).

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


e.

Tighten the 2 bolts (B).

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


f.

Connect the No. 3 water by-pass hose and No. 4 water by-pass hose to the EGR cooler assembly and slide the 2 clips to secure them.


Hide 2.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 4.ADD ENGINE COOLANT