| Battery terminal is disconnected/reconnected
|
Perform steering sensor zero point calibration
|
Lane departure alert system (w/ Steering Control)
|
( )
|
| Pre-collision system
|
| Memorize steering angle neutral point
|
Parking assist monitor system
|
( )
|
| Replacement of ECM
|
Perform Vehicle Identification Number (VIN) or frame number registration
|
MIL comes on
|
( )
|
| Perform code registration (Immobiliser system)
|
Engine start function
|
See Service Bulletin for the registration method.
|
| Gas leak from exhaust system is repaired
|
Inspection After Repair
|
·
Engine start function, etc.
|
( )
|
Replacement of ECM
(If possible, read the transaxle compensation code from the previous ECM)
|
2.
Transfer transaxle compensation code
3.
Perform road test to allow ECM to learn
|
·
Deterioration of fuel efficiency
|
( )for UB80E Initialization
( )for UB80E Registration
|
Replacement of ECM
(If impossible, read the transaxle compensation code from the previous ECM)
|
2.
Reset transaxle compensation code
3.
Perform road test to allow ECM to learn
|
| Replacement of ECM
|
Perform code registration (Immobiliser function)
|
·
Wireless door lock control system
·
Smart Entry and Start System (for Entry Function)
·
Smart Entry and Start System (for Start Function)
|
See Service Bulletin for the registration method.
|
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
|
Rear television camera assembly optical axis (Back camera position setting)
|
Parking assist monitor system
|
( )for Initialization
( )for Calibration
|
| Perform headlight ECU sub-assembly LH initialization
|
Lighting system (EXT)
|
( )
|
| Front wheel alignment adjustment
|
Perform system variant learning and acceleration sensor zero point calibration.
|
·
VSC disabled or malfunctioning
·
Slip indicator light illuminated
·
ABS warning light illuminated
|
( )
|