Home › Engine / Hybrid System › A25A-FKS (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR
RM33A0E _51 Engine / Hybrid System _065341 A25A-FKS ENGINE CONTROL _0328596 CAMSHAFT POSITION SENSOR A

A25A-FKS ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 11102A 2.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)

a.
A402366

Disconnect the camshaft position sensor connector.


b.

Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.



Hide 11102A 3.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)

a.

Disconnect the camshaft position sensor connector.


b.
A402367

Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.

NOTICE:

If the camshaft position sensor has been struck or dropped, replace it.