The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crankshaft position sensor removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
28100
1.REMOVE STARTER ASSEMBLY
11401G
2.REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector.
Using an 8 mm socket wrench, remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
If the crankshaft position sensor has been struck or dropped, replace it.