Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM33A0E _58 Vehicle Interior _065385 SEAT _0328609 SEAT HEATER SYSTEM U

SEAT  SEAT HEATER SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Seat Heater Temperature Front seat RH side seat heater temperature -29.7°C to 59.55°C Within range from 35 to 42°C (95 to 108°F) Front seat heater is on
FL Seat Heater Temperature Front seat LH side seat heater temperature -29.7°C to 59.55°C Within range from 35 to 42°C (95 to 108°F) Front seat heater is on
Number of Trouble Codes Number of trouble codes 0 to 255 Number of DTCs will be displayed -


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Front Right Seat Heater Front seat RH side seat heater operation OFF or ON -
Front Left Seat Heater Front seat LH side seat heater operation OFF or ON -