Home › Engine / Hybrid System › 2AR-FE (INTAKE / EXHAUST) › INTAKE MANIFOLD › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065327 2AR-FE INTAKE / EXHAUST _0328637 INTAKE MANIFOLD G

2AR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  INSPECTION  


PROCEDURE

Hide 1.INSPECT INTAKE AIR CONTROL VALVE (for ACIS)

a.

Inspect the diaphragm.

i.
A315822

Using a vacuum pump, apply a vacuum of 60 kPa (450 mmHg, 17.7 in. Hg) or more to the diaphragm chamber. Check that there is no change in vacuum after 1 minute.

If the result is not as specified, replace the intake manifold.


ii.

Check that the actuator rod operates when vacuum is applied.

If the actuator rod does not operate when vacuum is applied, replace the intake manifold.



Hide 2.INSPECT VACUUM TANK AND NO. 1 CHECK VALVE

a.
A197175

Disconnect the vacuum hose from the No. 1 check valve.


b.

Using a vacuum pump, apply vacuum to the No. 1 check valve. Check that there is no change in vacuum after 1 minute.

If the result is not as specified, replace the No. 1 check valve.


c.

Connect the vacuum hose to the No. 1 check valve.


d.
A196058

Using a vacuum pump, apply a vacuum of 60 kPa (450 mmHg, 17.7 in. Hg) or more to the vacuum tank. Check that there is no change in vacuum after 1 minute.

If the result is not as specified, replace the intake manifold.