Home › General › SPECIFICATIONS › A25A-FKS INTAKE / EXHAUST
RM33A0E _V1 General _065355 SPECIFICATIONS _0318934 A25A-FKS INTAKE / EXHAUST F

SPECIFICATIONS  A25A-FKS INTAKE / EXHAUST  TORQUE SPECIFICATIONS  


INTAKE MANIFOLD
Part Tightened N*m kgf*cm ft.*lbf in.*lbf
Stud bolt x Cylinder head sub-assembly 6.5 66 58
Intake manifold x Cylinder head sub-assembly 24 245 18
No. 3 water by-pass pipe x Intake manifold 10 102 7
No. 2 water by-pass pipe x Cylinder block sub-assembly 21 214 15
No. 2 water by-pass pipe x Intake manifold 10 102 7
Engine wire x Intake manifold 10 102 7

EXHAUST MANIFOLD
Part Tightened N*m kgf*cm ft.*lbf in.*lbf
No. 2 exhaust manifold heat insulator x Exhaust manifold (TWC: Front Catalyst) 11 112 8
Exhaust manifold (TWC: Front Catalyst) x Cylinder head sub-assembly 26 265 19
Manifold stay x Exhaust manifold (TWC: Front Catalyst) and Cylinder block sub-assembly 43 438 32
No. 1 exhaust manifold heat insulator x Exhaust manifold (TWC: Front Catalyst) 10 102 7
No. 1 upper front floor heat insulator x Vehicle body 4.9 50 43
Wire harness clamp bracket x Water hose clamp bracket 13 133 10

EXHAUST PIPE
Part Tightened N*m kgf*cm ft.*lbf in.*lbf
Front exhaust pipe assembly (TWC: Rear Catalyst) x Exhaust manifold (TWC: Front Catalyst) 43 438 32
Center exhaust pipe assembly x Front exhaust pipe assembly (TWC: Rear Catalyst) 43 438 32
Tail exhaust pipe assembly x Center exhaust pipe assembly 43 438 32
Center floor crossmember brace x Vehicle body 15 153 11
Front center floor brace x Vehicle body 15 153 11
Front floor cover LH x Vehicle body 7.5 76 66
Front floor cover RH x Vehicle body 7.5 76 66