Home › Engine / Hybrid System › A25A-FKS (LUBRICATION) › OIL PRESSURE SENSOR › 2017.09–2019.10
RM33A0E _51 Engine / Hybrid System _065347 A25A-FKS LUBRICATION _0328786 OIL PRESSURE SENSOR A

A25A-FKS LUBRICATION  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 83520 1.INSTALL OIL PRESSURE SENSOR (OIL PRESSURE SENDER GAUGE ASSEMBLY)

a.
A304094C14
1.469,0.344 1.646,0.344 1.646,0.344 1.927,0.688 false 1.792,1.229 1.99,1.563 1.99,1.563 2.219,1.563 false 1.302,0.229 1.615,0.385 0.313,0.156 10 false *a 2.25,1.458 2.563,1.615 0.313,0.156 10 false *b
*a Adhesive 1344
*b Oil Inlet Port


Apply adhesive to 2 or 3 threads of the oil pressure sensor (oil pressure sender gauge assembly).

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
·

Do not apply adhesive to the oil inlet port of the oil pressure sensor (oil pressure sender gauge assembly).

·

Install the oil pressure sensor (oil pressure sender gauge assembly) within 3 minutes of applying adhesive.




b.

Using a 27 mm deep socket wrench, install the oil pressure sensor (oil pressure sender gauge assembly) to the cylinder block sub-assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)


c.

Connect the oil pressure sensor (oil pressure sender gauge assembly) connector.


Hide 2.INSPECT FOR ENGINE OIL LEAK

Hide 3.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

Hide 53852K 5.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

Hide 53851M 6.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH