Home › Engine / Hybrid System › A25A-FKS (LUBRICATION) › OIL PRESSURE SENSOR › 2017.09–2019.10
RM33A0E _51 Engine / Hybrid System _065347 A25A-FKS LUBRICATION _0328786 OIL PRESSURE SENSOR A

A25A-FKS LUBRICATION  OIL PRESSURE SENSOR  REMOVAL  


PROCEDURE

Hide 53851M 1.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Hide 53852K 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 4.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

Hide 83520 5.REMOVE OIL PRESSURE SENSOR (OIL PRESSURE SENDER GAUGE ASSEMBLY)

a.

Disconnect the oil pressure sensor (oil pressure sender gauge assembly) connector.


b.
A402127

Using a 27 mm deep socket wrench, remove the oil pressure sensor (oil pressure sender gauge assembly) from the cylinder block sub-assembly.