83530
1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
| *1 | Wire Harness Protector |
Disengage the clamp to disconnect the wire harness protector.
Disconnect the engine oil pressure switch assembly connector.
Start the engine.
| *a | Engine Oil Pressure Switch Assembly Body |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - Engine oil pressure switch assembly body | Idling | 10 kΩ or higher |
| Engine stopped | Below 1 Ω |
If the result is not as specified, replace the engine oil pressure switch assembly.
Connect the engine oil pressure switch assembly connector.
Connect the wire harness protector.