Home › Power Source / Network › 2GR-FKS (BATTERY / CHARGING) › GENERATOR
RM33A0E _57 Power Source / Network _065340 2GR-FKS BATTERY / CHARGING _0328814 GENERATOR G

2GR-FKS BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A128079C17
0.698,0.688 0.875,0.854 0.177,0.167 10 *a
*a Length


Using a vernier caliper, measure the length of the exposed brushes.

Standard Exposed Brush Length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum Exposed Brush Length:

4.5 mm (0.177 in.)


If the brush length is less than the minimum, replace the generator brush holder assembly.


Hide 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A298009C03
1.698,0.896 2.406,0.417 2.406,0.417 1.854,0.948 true 2.469,0.281 2.781,0.438 0.313,0.156 10 false *a
*a Slip Ring


Check the generator rotor assembly for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.8 to 2.2 Ω


If the result is not as specified, replace the generator rotor assembly.



b.
A298010C04
0.333,0.188 0.531,0.188 0.531,0.188 0.917,0.635 true 1.823,0.958 2.135,0.615 2.135,0.615 2.396,0.615 true 2.427,0.563 2.74,0.719 0.313,0.156 10 false *a 0.167,0.115 0.479,0.271 0.313,0.156 10 false *b
*a Slip Ring
*b Rotor


Check the generator rotor assembly for a short to ground.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor Always 1 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



c.
A192784

Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.

If the generator rotor bearing is rough or worn, or does not rotate smoothly, replace the generator rotor assembly.


d.
A097470C06
0.646,0.094 0.813,0.25 0.167,0.156 10 *a
*a Diameter


Check the slip ring.

i.

Check that the slip rings are not rough or scored.

If the slip rings are rough or scored, replace the generator rotor assembly.


ii.

Using a vernier caliper, measure the slip ring diameter.

Standard Diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum Diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.



Hide 3.INSPECT GENERATOR DRIVE END FRAME BEARING

a.
A407306

Check that the generator drive end frame bearing is not rough or worn and that it rotates smoothly.

If the generator drive end frame bearing is rough or worn, or does not rotate smoothly, replace the generator drive end frame bearing.