Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System) › 2017.09–2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0328874 TOYOTA PARKING ASSIST-SENSOR SYSTEM D

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  CALIBRATION  


NOTICE:

When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the TOYOTA parking assist-sensor system may not operate correctly.


ADJUST TOYOTA PARKING ASSIST-SENSOR SYSTEM


a.

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TOYOTA parking assist-sensor system removal/installation are shown below.

Part Name Operation Adjustment Item Proceed to
Clearance warning ECU assembly Replacement Registration of bumper type Procedure 1
Ultrasonic sensor Initialization of front corner ultrasonic sensor (LH, RH) Procedure 2
Initialization of rear corner ultrasonic sensor (LH, RH)



Registration of Bumper Type (PROCEDURE 1)


a.

Preparation

i.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System)>DIAGNOSTIC TROUBLE CODE CHART

NOTICE:

If DTC C1AF3, C1AF4 or C168D is output, continue with the registration procedure.




b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Utility.

Body Electrical > IPA/ICS/Clearance Sonar > Utility
Tester Display
Clearance Sonar Detection/Steering Adjustment
50005 170 4402

f.

Select "Clearance Sonar ECU" and perform steering adjustment according to the display on the GTS.


g.

Enter the bumper type using the GTS.

Bumper Type Value
for Bar Type Radiator Grille 1
for Mesh Type Radiator Grille 2


h.

Disconnect the GTS from the DLC3.



Registration of Ultrasonic Sensors (PROCEDURE 2)


a.

Preparation

i.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System)>DIAGNOSTIC TROUBLE CODE CHART

NOTICE:

If DTC C1AEC, C1AED or C168D is stored, continue with the registration procedure.




b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Utility.

Body Electrical > IPA/ICS/Clearance Sonar > Utility
Tester Display
Clearance Sonar Detection/Steering Adjustment
50005 170 4402

f.

Select "Fr Sensor or Bumper" or "Rr Sensor or Bumper" and perform automatic adjustment according to the display on the GTS.

HINT:

It is not required to enter sensor angles. Perform the procedure according to the display on the GTS.



g.

Disconnect the GTS from the DLC3.