CLEARANCE WARNING ECU ASSEMBLY
Disconnect the R39 clearance warning ECU assembly connector.
Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| R39-1 (IG) - R39-30 (E) | IG power source signal | Engine switch off | Below 1 V |
| Engine switch on (IG) | 11 to 14 V | ||
| R39-30 (E) - Body ground | Ground | Always | Below 1 Ω |
Reconnect the R39 clearance warning ECU assembly connector.
Measure the voltage and check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| R39-4 (BOF) - R39-30 (E) | Power source for front sensor circuit | Engine switch off | Below 1 V |
·
Engine switch on (IG) ·
TOYOTA parking assist-sensor system on |
11 to 14 V | ||
| R39-6 (E5) - R39-30 (E) | Ground for front clearance sonar | Always | Below 1 V |
| R39-8 (SOF) - R39-30 (E) | Front sensor communication signal (Front clearance sonar sensor) | ·
Engine switch on (IG) ·
TOYOTA parking assist-sensor system on ·
Shift lever in R ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
Pulse generation
(Refer to waveform 1) |
| R39-13 (EF) - R39-30 (E) | Ground for clearance warning buzzer | Always | Below 1 V |
| R39-14 (CBZ) - R39-13 (EF) | Clearance warning buzzer signal | Buzzer sounding | Pulse generation
(Refer to waveform 2) |
| R39-22 (BOR) - R39-30 (E) | Power source for rear sensor circuit | Engine switch off | Below 1 V |
·
Engine switch on (IG) ·
TOYOTA parking assist-sensor system on |
11 to 14 V | ||
| R39-23 (E1) - R39-30 (E) | Ground for rear clearance sonar | Always | Below 1 V |
| R39-24 (SOR) - R39-30 (E) | Rear sensor communication signal (Rear clearance sonar sensor) | ·
Engine switch on (IG) ·
TOYOTA parking assist-sensor system on ·
Shift lever in R ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
Pulse generation
(Refer to waveform 1) |
Using an oscilloscope, check waveform 1.
Waveform 1 (Reference)
| Item | Content |
|---|---|
| Measurement terminal | ·
CH1: R39-8 (SOF) - R39-30 (E) ·
CH2: R39-24 (SOR) - R39-30 (E) |
| Measurement setting | 5 V/DIV., 1 ms./DIV. |
| Condition | ·
Engine switch on (IG) ·
TOYOTA parking assist-sensor system on ·
Shift lever in R ·
Vehicle speed is less than approximately 10 km/h (6 mph) |
The waveforms for CH1 and CH2 are same.
Using an oscilloscope, check waveform 2.
Waveform 2 (Reference)
| Item | Content |
|---|---|
| Measurement terminal | R39-14 (CBZ) - R39-13 (EF) |
| Measurement setting | 2 V/DIV., 500 μs./DIV. |
| Condition | Buzzer sounding |
The amplitude of the waveform changes according to the set volume.