Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Parking Support Brake System) › 2017.09–2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0328874 TOYOTA PARKING ASSIST-SENSOR SYSTEM U

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > IPA/ICS/Clearance Sonar > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Main Switch TOYOTA parking assist-sensor system switch assembly (Multi-information switch) OFF or ON OFF: TOYOTA parking assist-sensor system off
ON: TOYOTA parking assist-sensor system on
-
Initial Steering Angle Set Status of initial steering angle setting Not Yet or Done Not Yet: Not completed
Done: Completed
-
Current Steering Angle Set Status of current steering angle setting Unset or Set Unset: Not completed
Set: Completed
-
Clearance Sonar ECU Type Type of clearance sonar ECU Normal Normal: Normal clearance sonar type -
ICS SW Status Intelligent clearance sonar system switch assembly (Multi-information switch) OFF or ON OFF: Intelligent clearance sonar system off
ON: Intelligent clearance sonar system on
-
Fr Left Sensor Front left sensor information Undetect, Close R, Mid Y, Mid L Y, Freeze, Open or Blink Undetect: Not detected
Close R: Detected (Close-range) [Red]
Mid Y: Detected (Medium-range) [Yellow]
Mid L Y: Detected (Long-range) [Yellow]
Freeze: Sensor frozen
Open: Open in sensor
Blink: All displays blinking
-
Fr Right Sensor Front right sensor information Undetect, Close R, Mid Y, Mid L Y, Freeze, Open or Blink Undetect: Not detected
Close R: Detected (Close-range) [Red]
Mid Y: Detected (Medium-range) [Yellow]
Mid L Y: Detected (Long-range) [Yellow]
Freeze: Sensor frozen
Open: Open in sensor
Blink: All displays blinking
-
Rr Left Sensor Rear left sensor information Undetect, Close R, Mid Y, Mid L Y, Freeze, Open or Blink Undetect: Not detected
Close R: Detected (Close-range) [Red]
Mid Y: Detected (Medium-range) [Yellow]
Mid L Y: Detected (Long-range) [Yellow]
Freeze: Sensor frozen
Open: Open in sensor
Blink: All displays blinking
-
Rr Right Sensor Rear right sensor information Undetect, Close R, Mid Y, Mid L Y, Freeze, Open or Blink Undetect: Not detected
Close R: Detected (Close-range) [Red]
Mid Y: Detected (Medium-range) [Yellow]
Mid L Y: Detected (Long-range) [Yellow]
Freeze: Sensor frozen
Open: Open in sensor
Blink: All displays blinking
-
Fr Sensor Onset Range Detection operation range (for front center sensors) Narrow or Wide Narrow: 600 mm (23.6 in.)
Wide: 1000 mm (39.4 in.)
Customized value displayed
Rr Sensor Onset Range Detection operation range (for rear center sensors) Narrow or Wide Narrow: 600 mm (23.6 in.)
Wide: 1500 mm (59.1 in.)
Customized value displayed
Keep Sense Buzzer Keep sense buzzer operation Not Avail or Avail Not Avail: Buzzer stops
Avail: Buzzer sounds continuously
Customized value displayed
Fr & Rr Buzzer Volume Buzzer volume setting L, M1, M2, M3 or H L: Low volume
M1: Medium low volume
M2: Medium volume
M3: Medium high volume
H: High volume
Customized value displayed
Sensor Condition N Front sensor operation Not Avail or Avail Not Avail: Front sensors not available
Avail: Front sensors available
Customized value displayed
Approach Display OFF Whether the display turns off after an obstacle is no longer detected. Not Avail or Avail Not Avail: Not displayed
Avail: Displayed
Customized value displayed
Object Not Moving 3s Buzz Vol The volume at which the buzzer sounds when the distance between the vehicle and a detected object does not change for 3 seconds. Keep Vol, L, M1 or M2 Keep Vol: Keep volume
L: High
M1: Medium
M2: Medium low
Customized value displayed
Leave Buzzer Volume The volume of the buzzer with respect to the distance between the vehicle and a detected object. Keep Vol, L, M1 or M2 Keep Vol: Keep volume
L: High
M1: Medium
M2: Medium low
Customized value displayed
Fr Corner Sensor Onset Range Sets the detection operation range for the front corner sensors. Short or Long Short: 450 mm (17.7 in.)
Long: 600 mm (23.6 in.)
Customized value displayed
Rr Corner Sensor Onset Range Sets the detection operation range for the rear corner sensors. Short or Long Short: 450 mm (17.7 in.)
Long: 600 mm (23.6 in.)
Customized value displayed
Display Mode Display mode setting All or Undisp All: Display displays all sensors
Undisp: Display does not display
Customized value displayed
Temporary Mute Reset Speed Adjust Temporary mute reset speed adjustment setting System Link, 15 km/h, 20 km/h or 30 km/h System Link: Adjustment will not be canceled due to vehicle speed
15 km/h: Adjustment will be canceled when vehicle speed reaches 15 km/h
20 km/h: Adjustment will be canceled when vehicle speed reaches 20 km/h
30 km/h: Adjustment will be canceled when vehicle speed reaches 30 km/h
Customized value displayed
Temporary Mute Function Temporary mute function setting OFF or ON OFF: Temporary Mute Function not operating
ON: Temporary Mute Function operating
Customized value displayed
IPA System Existence of intelligent parking assist system Without, With or Unfixed Without: w/o Intelligent parking assist system
With: w/ Intelligent parking assist system
Unfixed: Unknown
-
Parking Signal Parking signal OFF or ON OFF: Shift lever in any position other than P
ON: Shift lever in P
-
Reverse Signal Reverse signal OFF or ON OFF: Shift lever not in R
ON: Shift lever in R
-
Clearance Sonar ECU Clearance warning ECU assembly information Normal or Abnormal Normal: Clearance warning ECU assembly normal
Abnormal: Clearance warning ECU assembly not normal
-
Rr Right Freezed History Rear right sensor frozen history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Rr Left Freezed History Rear left sensor frozen history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Fr Right Freezed History Front right sensor frozen history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Fr Left Freezed History Front left sensor frozen history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Steering Wheel Location Location of the steering wheel Right, Left or Unfixed Right: RH side
Left: LH side
Unfixed: Unknown
-
HV System Existence of hybrid system Without, With or Unfixed Without: w/o Hybrid system
With: w/ Hybrid system
Unfixed: Unknown
-
Rear Right Sensor Dirty Rear right sensor dirt history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Rear Left Sensor Dirty Rear left sensor dirt history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Front Right Sensor Dirty Front right sensor dirt history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Front Left Sensor Dirty Front left sensor dirt history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Target 1 Distance (FLC Sensor) Distance between ultrasonic sensor and target object Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.) Unknown: Detection conditions not met
Not Detected: No objects detected 0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance
-
Target 1 Distance (FRC Sensor) Distance between ultrasonic sensor and target object Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.) Unknown: Detection conditions not met
Not Detected: No objects detected 0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance
-
Target 1 Distance (RLC Sensor) Distance between ultrasonic sensor and target object Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.) Unknown: Detection conditions not met
Not Detected: No objects detected 0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance
-
Target 1 Distance (RRC Sensor) Distance between ultrasonic sensor and target object Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.) Unknown: Detection conditions not met
Not Detected: No objects detected 0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance
-
Target 1 Distance (FL Sensor) Distance between ultrasonic sensor and target object Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.) Unknown: Detection conditions not met
Not Detected: No objects detected 0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance
-
Target 1 Distance (FR Sensor) Distance between ultrasonic sensor and target object Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.) Unknown: Detection conditions not met
Not Detected: No objects detected 0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance
-
ICS System Existence of intelligent clearance sonar system Without or With Without: w/o Intelligent clearance sonar system
With: w/ Intelligent clearance sonar system
-
Bumper Type Registered bumper type Unfixed or 1 to 127 1: Standard
2 to 127: Unknown
Unfixed: Unknown
-
# Codes Number of stored DTCs min.: 0, max.: 255 Number of DTCs will be displayed -


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / IPA/ICS/Clearance Sonar / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Body Electrical > IPA/ICS/Clearance Sonar > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Buzzer No. 1 clearance warning buzzer Stop or Operate Confirm that the vehicle is stopped and the engine switch is on (IG)