Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2017.09–2021.02
RM33A0E _58 Vehicle Interior _065384 PRE-COLLISION _0319645 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C1A46  Yaw Rate Sensor  


DESCRIPTION

If the millimeter wave radar sensor assembly receives a yaw rate sensor malfunction signal from the yaw rate sensor (airbag sensor assembly) or yaw rate sensor zero point malfunction signal from the skid control ECU (brake actuator assembly), DTC C1A46 will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A46 Yaw Rate Sensor
·

While the vehicle is being driven at a speed of 5 km/h (4 mph) or more, the millimeter wave radar sensor assembly receives a yaw rate sensor malfunction signal from the yaw rate sensor for approximately 10 seconds.

·

While the vehicle is being driven at a speed of 5 km/h (4 mph) or more, the millimeter wave radar sensor assembly receives a yaw rate sensor zero point malfunction signal from the skid control ECU (brake actuator assembly) for approximately 10 seconds.


·

Vehicle stability control system

·

Millimeter wave radar sensor assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT

·

The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
HINT:

Pre-collision system DTC C1A46 may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first.


a.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
Vehicle stability control system DTCs are not output A
Vehicle stability control system DTCs are output B



A

2.CHECK FOR DTCs (PRE-COLLISION SYSTEM)

B

2.CHECK FOR DTCs (PRE-COLLISION SYSTEM)
a.

Clear the DTCs.

Body Electrical > Pre-Collision 2 > Clear DTCs
50002 220

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Drive the vehicle at a speed of 5 km/h (4 mph) or more for 10 seconds or more.




c.

Check for DTCs.

Body Electrical > Pre-Collision 2 > Trouble Codes
50001 220

Result:
Result Proceed to
DTC C1A46 is not output A
DTC C1A46 is output B



A

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY