When the pre-collision system is operating, the millimeter wave radar sensor assembly sends brake control signals to the skid control ECU (brake actuator assembly).
If the millimeter wave radar sensor assembly receives a vehicle stability control system malfunction signal from the skid control ECU (brake actuator assembly) via CAN communication, DTC C1A50 will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1A50 | Brake System Malfunction | While the engine switch is on (IG), the millimeter wave radar sensor assembly receives a vehicle stability control system malfunction signal from the skid control ECU (brake actuator assembly) for 1 second or more. | ·
Vehicle stability control system ·
Millimeter wave radar sensor assembly |
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Pre-collision system DTC C1A50 may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Vehicle stability control system DTCs are not output | A |
| Vehicle stability control system DTCs are output | B |
A
B
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the engine switch on (IG) and wait 1 second or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1A50 is not output | A |
| DTC C1A50 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B