Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)
RM33A0E _58 Vehicle Interior _065387 HEATING / AIR CONDITIONING _0327417 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  B1447  Air Mix Damper Control Servo Motor Circuit (Rear)  


DESCRIPTION

The No. 3 air conditioning radiator damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the No. 3 air conditioning radiator damper servo sub-assembly to the appropriate position. As a result, the amount of air passing through the heater core after passing through the evaporator is adjusted, and the temperature of the air blowing toward the rear side is controlled. The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1447 Air Mix Damper Control Servo Motor Circuit (Rear) Air mix damper position sensor value does not change even if air conditioning amplifier assembly operates No. 3 air conditioning radiator damper servo sub-assembly
·

No. 3 air conditioning radiator damper servo sub-assembly

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly

·

Air conditioning radiator assembly


Memorized
(30 sec. or more)*

*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.


DTC Detection Condition Combination Table
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition No. 3 air conditioning radiator damper servo sub-assembly operating ○ ○
Malfunction Air mix damper servo operation request signals are output but the air mix damper position sensor value does not change ○ -
Air mix damper servo operation request signals are output but the air mix damper position sensor value is abnormal - ○
Detection Time Continuously for 30 seconds or more Continuously for 30 seconds or more
Trip Count 1 trip 1 trip

HINT:

If the conditions of either of these patterns are detected, a DTC will be stored.


WIRING DIAGRAM

E380657E01
6.604,0.583 6.917,0.781 0.313,0.198 10 false +B 6.76,1.302 6.938,1.49 0.177,0.188 10 false IC 2.542,1.292 2.719,1.479 0.177,0.188 10 false IC 0.219,2.646 2.625,3.042 2.406,0.396 10 false No. 3 Air Conditioning Radiator Damper Servo Sub-assembly 0.823,3.302 2.5,3.521 1.677,0.219 10 false : LIN Communication Line 2.844,2.656 5.104,2.875 2.26,0.219 10 false Air Conditioning Harness Assembly 5.521,2.552 7.073,2.927 1.552,0.375 10 false Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

HINT:
·

Confirm that no mechanical problems are present because this DTC can be stored when either a damper link or damper is mechanically locked.

·

When installing a damper servo motor, make sure to install it correctly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>REASSEMBLY

·

After replacing a damper servo motor, make sure to perform Servo Motor Initialization.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>INITIALIZATION



PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
B1497 is not output A
B1497 is output B



A

2.INSPECT NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (INSTALLATION CONDITION)

B

2.INSPECT NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (INSTALLATION CONDITION)
a.

Check that the No. 3 air conditioning radiator damper servo sub-assembly is installed correctly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>REASSEMBLY

OK:

The No. 3 air conditioning radiator damper servo sub-assembly is installed correctly.



Result:
Proceed to
OK
NG



OK

3.INSPECT NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (MOTOR, LINK, DAMPER)

NG

INSTALL NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY CORRECTLY

3.INSPECT NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (MOTOR, LINK, DAMPER)
a.

Check for a wire harness caught between the links of the motors and dampers.

OK:

No wire harnesses are caught between the links of the motors and dampers.



Result:
Proceed to
OK
NG



OK

4.INSPECT AIR CONDITIONING RADIATOR ASSEMBLY (DAMPER)

NG

REMOVE PINCHED WIRE HARNESS

4.INSPECT AIR CONDITIONING RADIATOR ASSEMBLY (DAMPER)
a.

Remove the No. 3 air conditioning radiator damper servo sub-assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY


b.

Operate the dampers by hand.

OK:

The dampers are easily operated by hand.



Result:
Proceed to
OK
NG



OK

5.PERFORM ACTIVE TEST USING GTS

NG

REPLACE AIR CONDITIONING RADIATOR ASSEMBLY

5.PERFORM ACTIVE TEST USING GTS
a.

Remove the No. 2 air conditioning radiator damper servo sub-assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY


b.

Connect the No. 2 air conditioning radiator damper servo sub-assembly connector to the No. 3 air conditioning radiator damper servo sub-assembly.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


g.

Perform the Active Test according to the display on the GTS.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
A/O Servo Pulse(Rr D) No. 2 air conditioning radiator damper servo sub-assembly pulse* Min.: 128
Max.: 383
Operates between 158 to 260 pulses

*: Though this Active Test is for the No. 2 air conditioning radiator damper servo sub-assembly, in this case it is used to check the operation of the No. 3 air conditioning radiator damper servo sub-assembly.


Body Electrical > Air Conditioner > Active Test
Tester Display
A/O Servo Pulse(Rr D)
50004 121 56
OK:

The No. 3 air conditioning radiator damper servo sub-assembly operates.



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING HARNESS ASSEMBLY

NG

REPLACE NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY