85942
1.INSPECT HEADLIGHT CLEANER CONTROL RELAY
Disconnect the headlight cleaner control relay connector.
| *a | Component without harness connected
(Headlight Cleaner Control Relay) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 (PB) - 4 (E) | Battery voltage applied between terminals 3 (IG) and 2 (H) | Below 1 Ω |
| Battery voltage not applied between terminals 3 (IG) and 2 (H) | 10 kΩ or higher |
If the result is not as specified, replace the headlight cleaner control relay.