Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM
RM33A0E _58 Vehicle Interior _065388 POWER OUTLETS (INT) _0329463 WIRELESS CHARGING SYSTEM J

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM  Wireless Charger Power Source Circuit  


DESCRIPTION

This is the power source circuit for the mobile wireless charger cradle assembly (front console box insert sub-assembly).

WIRING DIAGRAM

E216158E02
0.792,0.635 1.635,0.885 0.844,0.25 10 false from Battery 0.563,1.427 1.646,1.927 1.083,0.5 10 false from ACC Relay 2.552,0.802 3.854,1.063 1.302,0.26 10 false ECU-DCC NO. 2 2.75,1.604 3.5,1.958 0.75,0.354 10 false ECU-ACC 4.375,0.521 4.625,0.792 0.25,0.271 10 false 6 4.385,1.313 4.635,1.583 0.25,0.271 10 false 5 4.385,2.125 4.635,2.396 0.25,0.271 10 false 1 4.625,0.646 5.125,0.979 0.5,0.333 10 false B+ 4.635,1.333 5.135,1.667 0.5,0.333 10 false ACC 4.615,2.25 5.115,2.583 0.5,0.333 10 false PGND 4.417,2.75 4.917,3 0.5,0.25 10 false k1 4.417,2.927 7,3.51 2.583,0.583 10 false Mobile Wireless Charger Cradle Assembly (Front Console Box Insert Sub-assembly) 5.802,1.438 6.302,1.771 0.5,0.333 10 false IC

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (FRONT CONSOLE BOX INSERT SUB-ASSEMBLY) POWER SOURCE)
a.

Disconnect the k1 mobile wireless charger cradle assembly (front console box insert sub-assembly) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
k1-1 (PGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
k1-6 (B+) - Body ground Always 11 to 14 V
k1-5 (ACC) - Body ground Ignition switch ACC 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR