The headlight ECU sub-assembly LH or headlight ECU sub-assembly RH stores this DTC if it detects an internal malfunction related to the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U1000 | CAN Communication Failure (Message Registry) | Detection condition:
The ignition switch is ON. Malfunction status:
CAN communication failure Malfunction duration:
- |
Headlight ECU sub-assembly LH | HL AutoLeveling |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U1000 | CAN Communication Failure (Message Registry) | Detection condition:
The ignition switch is ON. Malfunction status:
CAN communication failure Malfunction duration:
- |
Headlight ECU sub-assembly RH | HL AutoLeveling (Sub) |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling or HL AutoLeveling (Sub) / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling or HL AutoLeveling (Sub) / Trouble Codes.
Check for DTCs.
DTC U1000 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (DTC output from headlight ECU sub-assembly LH) | B |
| NG (DTC output from headlight ECU sub-assembly RH) | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C