This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AB0 | Short to +B in Outer Mirror Indicator(Master) | Both of the following conditions are met:
·
The blind spot monitor system is on ·
The blind spot monitor sensor is not sending voltage to the indicator but the indicator receives voltage above a specified level for a specified period of time |
·
Outer mirror RH ·
Outer rear view mirror assembly with cover RH ·
Wire harness or connector ·
Blind spot monitor sensor RH |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Turn the engine switch off.
Turn the engine switch on (IG).
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Disconnect the W5 blind spot monitor sensor RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W5-4 (OMIR) - Body ground | Engine switch on (IG) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the IND1 outer mirror RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W5-4 (OMIR) - Body ground | Engine switch on (IG) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N19 outer rear view mirror assembly with cover RH connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W5-4 (OMIR) - Body ground | Engine switch on (IG) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG