Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2017.09–2021.02
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328126 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Sound Quality is Bad Only when Disc is Played (Volume is Too Low)  


CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION

·

When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly may not operate normally.




PROCEDURE

1.CHECK MODEL
a.

Choose the model to be inspected.

Result:
Result Proceed to
for 6 Speakers A
for 9 Speakers B




A

2.REPLACE DISC AND RECHECK

B

3.REPLACE DISC AND RECHECK
2.REPLACE DISC AND RECHECK
a.

Replace the disc with a new or known good one and check that the malfunction disappears.

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.REPLACE DISC AND RECHECK
a.

Replace the disc with a new or known good one and check that the malfunction disappears.

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END

NG

4.CHECK NOISE CONDITION
4.CHECK NOISE CONDITION
a.

Check that noise is output from the speakers when a disc is inserted and is being read.

OK:

Noise is output.



Result:
Proceed to
OK
NG



OK

REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY