Home › Engine / Hybrid System › A25A-FKS (FUEL) › FUEL SENDER GAUGE ASSEMBLY (w/o Canister Pump Module) › from 2017.12
RM33A0E _51 Engine / Hybrid System _065343 A25A-FKS FUEL _0341523 FUEL SENDER GAUGE ASSEMBLY(w/o Canister Pump Module) A

A25A-FKS FUEL  FUEL SENDER GAUGE ASSEMBLY(w/o Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 83320 1.INSTALL FUEL SENDER GAUGE ASSEMBLY

a.

Engage the claw to install the fuel sender gauge assembly to the fuel suction tube with pump and gauge assembly.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



b.

Engage the 2 clamps to connect the wire harness to the fuel suction plate sub-assembly.

NOTICE:

Do not damage the wire harness.



c.

Connect the fuel sender gauge assembly connector.


Hide 77020A 2.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY