Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › from 2017.12
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0320460 WIPER SWITCH G

WIPER / WASHER  WIPER SWITCH  INSPECTION  


PROCEDURE

Hide 84650 1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (for LHD)

a.
E387688C01
1.198,1.583 1.365,1.583 1.365,1.583 1.365,1.25 true 1.333,1.75 1.5,1.75 1.5,1.75 1.5,1.25 true 1.479,1.917 1.646,1.917 1.646,1.917 1.646,1.25 true 1.958,1.917 1.792,1.917 1.792,1.917 1.792,1.25 true 2.083,1.75 1.917,1.75 1.917,1.75 1.917,1.25 true 2.229,1.583 2.063,1.583 2.063,1.583 2.063,1.25 true 1.958,0.417 1.792,0.417 1.792,0.417 1.792,0.969 true 1.469,0.417 1.635,0.417 1.635,0.417 1.635,0.969 true 0.5,2.167 0.667,2.167 0.667,2.167 1.417,2.417 true 0.5,1.833 0.667,1.833 0.667,1.833 1.427,2.292 true 0.5,2.5 0.667,2.5 0.667,2.5 1.448,2.5 true 0.5,2.833 0.667,2.833 0.667,2.833 1.469,2.615 true 0.292,2.75 0.604,2.948 0.313,0.198 10 false P1 0.292,2.417 0.604,2.615 0.313,0.198 10 false P2 0.292,2.083 0.604,2.281 0.313,0.198 10 false P3 0.292,1.76 0.604,1.958 0.313,0.198 10 false P4 1.26,1.823 1.573,2.021 0.313,0.198 10 false +S 1.99,1.823 2.302,2.021 0.313,0.198 10 false +2 2.125,1.656 2.438,1.854 0.313,0.198 10 false +1 2.271,1.479 2.781,1.74 0.51,0.26 10 false W-OFF 0.99,1.656 1.531,1.875 0.542,0.219 10 false MIST 0.938,1.479 1.448,1.74 0.51,0.26 10 false WF 0.115,0.115 0.625,0.375 0.51,0.26 10 false *a 1.344,0.344 1.854,0.604 0.51,0.26 10 false E 2,0.344 2.51,0.604 0.51,0.26 10 false VR
*a Component without harness connected
(Windshield Wiper Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Front Wiper Switch
Tester Connection Condition Specified Condition
14 (MIST) - 5 (E) MIST position Below 1 Ω
Except MIST position 10 kΩ or higher
10 (W-OFF) - 5 (E) OFF position Below 1 Ω
Except OFF position 10 kΩ or higher
13 (+S) - 5 (E) AUTO position*1 Below 1 Ω
INT position*2
Except AUTO position*1 10 kΩ or higher
Except INT position*2
11 (+1) - 5 (E) LO position Below 1 Ω
Except LO position 10 kΩ or higher
12 (+2) - 5 (E) HI position Below 1 Ω
Except HI position 10 kΩ or higher

Front Washer Switch
Tester Connection Condition Specified Condition
15 (WF) - 5 (E) ON position Below 1 Ω
OFF position 10 kΩ or higher

Auto Sensitivity Adjustment Switch*1
Tester Connection Condition Specified Condition
4 (VR) - 5 (E) P1 position 1102 to 1218 Ω
P2 position 570 to 630 Ω
P3 position 256.5 to 283.5 Ω
P4 position Below 1 Ω

Intermittent Time Adjustment Switch*2
Tester Connection Condition Specified Condition
4 (VR) - 5 (E) P1 position 1102 to 1218 Ω
P2 position 570 to 630 Ω
P3 position 256.5 to 283.5 Ω
P4 position Below 1 Ω


*1: w/ Auto Wiper System

*2: w/o Auto Wiper System


If the result is not as specified, replace the windshield wiper switch assembly.


Hide 84650 2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (for RHD)

a.
E387689C01
2.833,2.167 2.667,2.167 2.667,2.167 2.073,2.302 true 2.833,2.417 2.667,2.417 2.667,2.417 2.083,2.417 true 2.833,2.75 2.667,2.75 2.667,2.75 2.063,2.531 true 2.833,3.083 2.667,3.083 2.667,3.083 2.01,2.625 true 2.229,1.583 2.063,1.583 2.063,1.583 2.063,1.25 true 2.083,1.729 1.917,1.729 1.917,1.729 1.917,1.25 true 1.958,1.885 1.792,1.885 1.792,1.885 1.792,1.25 true 1.198,1.583 1.365,1.583 1.365,1.583 1.365,1.25 true 1.333,1.729 1.5,1.729 1.5,1.729 1.5,1.25 true 1.479,1.885 1.646,1.885 1.646,1.885 1.646,1.25 true 1.958,0.417 1.792,0.417 1.792,0.417 1.792,0.948 true 1.479,0.417 1.646,0.417 1.646,0.417 1.646,0.948 true 0.115,0.094 0.427,0.292 0.313,0.198 10 false *a 1.26,0.333 1.885,0.635 0.625,0.302 10 false VR 2.01,0.333 2.635,0.635 0.625,0.302 10 false E 2.271,1.49 2.896,1.792 0.625,0.302 10 false WF 0.708,1.49 1.333,1.792 0.625,0.302 10 false W-OFF 1.156,1.635 1.781,1.938 0.625,0.302 10 false +1 2.135,1.635 2.76,1.938 0.625,0.302 10 false MIST 1.292,1.781 1.917,2.083 0.625,0.302 10 false +2 1.99,1.781 2.615,2.083 0.625,0.302 10 false +S 2.865,2.083 3.427,2.385 0.563,0.302 10 false P4 2.865,2.333 3.427,2.635 0.563,0.302 10 false P3 2.865,2.656 3.427,2.958 0.563,0.302 10 false P2 2.865,3 3.427,3.302 0.563,0.302 10 false P1
*a Component without harness connected
(Windshield Wiper Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Front Wiper Switch
Tester Connection Condition Specified Condition
11 (MIST) - 4 (E) MIST position Below 1 Ω
Except MIST position 10 kΩ or higher
15 (W-OFF) - 4 (E) OFF position Below 1 Ω
Except OFF position 10 kΩ or higher
12 (+S) - 4 (E) AUTO position*1 Below 1 Ω
INT position*2
Except AUTO position*1 10 kΩ or higher
Except INT position*2
14 (+1) - 4 (E) LO position Below 1 Ω
Except LO position 10 kΩ or higher
13 (+2) - 4 (E) HI position Below 1 Ω
Except HI position 10 kΩ or higher

Front Washer Switch
Tester Connection Condition Specified Condition
10 (WF) - 4 (E) ON position Below 1 Ω
OFF position 10 kΩ or higher

Auto Sensitivity Adjustment Switch*1
Tester Connection Condition Specified Condition
5 (VR) - 4 (E) P1 position 1102 to 1218 Ω
P2 position 570 to 630 Ω
P3 position 256.5 to 283.5 Ω
P4 position Below 1 Ω

Intermittent Time Adjustment Switch*2
Tester Connection Condition Specified Condition
5 (VR) - 4 (E) P1 position 1102 to 1218 Ω
P2 position 570 to 630 Ω
P3 position 256.5 to 283.5 Ω
P4 position Below 1 Ω


*1: w/ Auto Wiper System

*2: w/o Auto Wiper System


If the result is not as specified, replace the windshield wiper switch assembly.