Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for Bulb Type Turn Signal Light) › from 2017.12
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0328283 HEADLIGHT ASSEMBLY(for Bulb Type Turn Signal Light) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for Bulb Type Turn Signal Light)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL HEADLIGHT ASSEMBLY

a.

w/ Automatic Headlight Beam Level Control System:

i.
E377992C01
0.365,2.979 0.531,2.74 true 2.188,2.99 2.333,2.844 true 0.208,2.958 0.521,3.156 0.313,0.198 10 true *a 1.958,2.948 2.271,3.146 0.313,0.198 10 true *a
*a Connector Lock Lever
V113147

Engage in this Direction


Connect the connector and raise the connector lock lever to engage the claw and lock the connector as shown in the illustration.



b.

w/o Automatic Headlight Beam Level Control System:

i.

Connect each connector.



c.
E377993C01
0,0 0,0 false
V113147

Install in this Direction


Engage the guide to temporarily install the headlight assembly as shown in the illustration.


d.
E375105C01
3.01,1.438 3.323,1.635 0.313,0.198 10 true *a 0.552,0.781 0.865,0.979 0.313,0.198 10 true *b 1.5,0.406 1.813,0.604 0.313,0.198 10 true *b 2.594,0.094 2.906,0.292 0.313,0.198 10 true *b
*a Bolt
*b Screw


Install the headlight assembly with the bolt and 3 screws.

Torque:
Bolt : 7.0 N*m (71 kgf*cm, 62 in.*lbf)


e.

Remove the protective tape.


Hide 2.INSTALL FRONT BUMPER ASSEMBLY

Hide 3.PERFORM INITIALIZATION (w/ Automatic Headlight Beam Level Control System)