Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type) › 2017.12–2021.02
RM33A0E _56 Audio / Visual / Telematics _065373 AUDIO / VIDEO _0323011 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B1550  DAB Tuner Malfunction  B158D  Video Signal Stoppage  B15A0  LAN Master Malfunction  B15B0  Display Screen Malfunction  B15B3  Radio Tuner Malfunction  B15B4  CD Changer Malfunction  B15B5  DVD Changer Malfunction  B15B7  Bluetooth Module Malfunction  B15F9  UART Communication Malfunction(for A/C)  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B1550 DAB Tuner Malfunction When any of the following conditions is met:
·

DAB tuner decoder malfunction

·

DAB tuner audio output section malfunction

·

DAB tuner decoder RF/IF malfunction

·

DAB tuner control communication error

·

DAB tuner OFDM error

·

DAB tuner memory error


Radio and display receiver assembly
B158D Video Signal Stoppage The interval video signal of the radio and display receiver assembly is interrupted Radio and display receiver assembly
B15A0 LAN Master Malfunction When either of the following conditions is met:
·

Bus malfunction

·

EEPROM error


Radio and display receiver assembly
B15B0 Display Screen Malfunction Picture circuit (TFT unit) malfunction Radio and display receiver assembly
B15B3 Radio Tuner Malfunction When any of the following conditions is met:
·

AM tuner PLL is unlocked

·

FM tuner PLL is unlocked

·

Tuner malfunction


Radio and display receiver assembly
B15B4 CD Changer Malfunction When any of the following conditions is met:
·

Mechanism drive signal malfunction

·

Load/Eject malfunction

·

Read mechanism malfunction

·

Mechanical malfunction


Radio and display receiver assembly
B15B5 DVD Changer Malfunction When any of the following conditions is met:
·

Mechanism drive signal malfunction

·

Load/Eject malfunction

·

Read mechanism malfunction

·

Mechanical malfunction


Radio and display receiver assembly
B15B7 Bluetooth Module Malfunction "Bluetooth" module malfunction Radio and display receiver assembly
B15F9 UART Communication Malfunction(for A/C) When either of the following conditions is met:
·

Open in UART communication line is detected during radio and display receiver assembly startup routine

·

Open in UART communication line is detected based on communication error


Radio and display receiver assembly

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type)>PRECAUTION


·

When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly may not operate normally.




PROCEDURE

1.CHECK DTC
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY