Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (except 2AR-FE) › 2017.12–2018.04
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0326622 CRUISE CONTROL SYSTEM(except 2AR-FE) J

CRUISE CONTROL  CRUISE CONTROL SYSTEM(except 2AR-FE)  Cruise Main Indicator Light Circuit  


DESCRIPTION

The ECM illuminates the cruise control indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control indicator illuminates when the cruise control system is turned on using the cruise control main switch. If a malfunction is detected, the cruise control indicator turns off and a warning message is displayed. The cruise control indicator circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the ECM, refer to Service Bulletin.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the cruise control indicator by performing the Active Test.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Multi Display All (White) Multi-information display (White display) ON -
Body Electrical > Combination Meter > Active Test
Tester Display
Multi Display All (White)
50004 409 20

Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test. B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Enter the following menus: Powertrain / Cruise Control / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Cruise Ready Main-CPU Cruise control system standby condition ON or OFF ON: Cruise control main switch pushed
OFF: Cruise control main switch not pushed
-
Cruise Ready Sub-CPU Cruise control system standby condition ON or OFF ON: Cruise control main switch pushed
OFF: Cruise control main switch not pushed
-
Cruise Indicator Cruise control indicator status ON or OFF ON: Cruise control indicator illuminates
OFF: Cruise control indicator turns off
-
Powertrain > Cruise Control > Data List
Tester Display
Cruise Ready Main-CPU
Cruise Ready Sub-CPU
Cruise Indicator
50003 374 22,21,17

Result:
Result Proceed to
The cruise control indicator illuminates and turns off according to the operation of the cruise control main switch. A
The cruise control indicator does not illuminate but the Data List items change according to the operation of the cruise control main switch. B
The cruise control indicator does not illuminate and the Data List items do not change according to the operation of the cruise control main switch. C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C