Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (for 2AR-FE) › 2017.12–2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0327281 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE)  P1578  Brake System  


DESCRIPTION

This DTC is stored when a malfunction is detected in the vehicle stability control system.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1578 Brake System While the ignition switch is ON and the dynamic radar cruise control system is operating, a malfunction in the vehicle stability control system is detected for 0.2 seconds or more.
·

Vehicle stability control system

·

ECM



CAUTION / NOTICE / HINT

NOTICE:
·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the ECM, refer to Service Bulletin.



PROCEDURE

1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

2.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)

B

2.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
a.

Clear the DTCs.

Powertrain > Radar Cruise1 > Clear DTCs
50002 239

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the ignition switch to ON.

2.

Turn the dynamic radar cruise control system on using the cruise control main switch.

3.

Wait for 1 second or more.




c.

Check for DTCs.

Powertrain > Radar Cruise1 > Trouble Codes
50001 239

Result:
Result Proceed to
DTC P1578 is not output A
DTC P1578 is output B



A

B