71075B
1.INSTALL BENCH TYPE REAR SEAT CUSHION COVER
When installing a bench type rear seat cushion cover, refer to Precaution in order to prevent wrinkles from forming.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>PRECAUTION
Engage the 24 claws.
Be careful not to damage the bench type rear seat cushion cover.
Engage the 20 hooks.
Be careful not to damage the bench type rear seat cushion cover.
Using hog ring pliers, install 2 new hog rings.
Be careful not to damage the bench type rear seat cushion cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seat cushion cover.
Using hog ring pliers, install 6 new hog rings.
Be careful not to damage the bench type rear seat cushion cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seat cushion cover.
Engage the 6 hooks.
Be careful not to damage the bench type rear seat cushion cover.
Engage the 4 fasteners to install the bench type rear seat cushion cover to the rear seat cushion pad sub-assembly.
|
Fastener | - | - |
Be careful not to damage the bench type rear seat cushion cover.
73733
2.INSTALL CHILD RESTRAINT SEAT BASE COVER
Use the same procedure for all child restraint seat base cover.
|
Install in this Direction |
Engage the guide and claw as shown in the illustration.
Install the child restraint seat base cover with the screw.
73731
3.INSTALL CHILD RESTRAINT SEAT COVER
|
Install in this Direction |
Engage the 2 guides and 2 claws to install the child restraint seat cover as shown in the illustration.
Use the same procedure for all child restraint seat covers.
71077B
4.INSTALL BENCH TYPE REAR SEATBACK COVER
When installing a bench type rear seatback cover, refer to Precaution in order to prevent wrinkles from forming.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>PRECAUTION
Engage the 16 claws.
Be careful not to damage the bench type rear seatback cover.
Using hog ring pliers, install the bench type rear seatback cover to the bench type rear seatback pad with 43 new hog rings.
Be careful not to damage the bench type rear seatback cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seatback cover.
73343
5.INSTALL REAR SEAT CENTER SHOULDER BELT GUIDE
Engage the guide.
Install the rear seat center shoulder belt guide with the 2 screws.
73343
6.INSTALL REAR SEAT SHOULDER BELT GUIDE RH
Engage the guide.
Install the rear seat shoulder belt guide RH with the 2 screws.
73344
7.INSTALL REAR SEAT SHOULDER BELT GUIDE LH
Engage the guide.
Install the rear seat shoulder belt guide LH with the 2 screws.