Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (except 2AR-FE) › 2017.12–2021.02
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0326623 DYNAMIC RADAR CRUISE CONTROL SYSTEM(except 2AR-FE) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(except 2AR-FE)  U010087  Lost Communication With ECM/PCM "A" Missing Message  U010487  Lost Communication with Cruise Control Module Missing Message  U012287  Lost Communication with Vehicle Dynamics Control Module Missing Message  


DESCRIPTION

The ECM communicates with each sensor and ECU via CAN communication.

If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U010087 Lost Communication With ECM/PCM "A" Missing Message While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the ECM continuously receives a communication cut-off signal from the skid control ECU (brake actuator assembly) for approximately 1 second or more.
·

CAN communication system

·

ECM

·

Skid control ECU (brake actuator assembly)


U010487 Lost Communication with Cruise Control Module Missing Message When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication error between the millimeter wave radar sensor assembly and ECM is detected for 1 second or more.
·

CAN communication system

·

ECM

·

Millimeter wave radar sensor assembly


U012287 Lost Communication with Vehicle Dynamics Control Module Missing Message When the ignition switch is ON and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake actuator assembly) and ECM is detected for approximately 2.6 seconds or more.
·

CAN communication system

·

ECM

·

Skid control ECU (brake actuator assembly)



PROCEDURE

1.CHECK FOR DTCs
a.

Clear the DTCs.

Powertrain > Cruise Control > Clear DTCs
50002 374

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the ignition switch to ON.

2.

Turn the dynamic radar cruise control system on using the cruise control main switch.

3.

Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.




c.

Check for DTCs.

Powertrain > Cruise Control > Trouble Codes
50001 374

Result:
Result Proceed to
DTC U010087, U010487 and U012287 are not output A
DTC U010087, U010487 or U012287 is output B



A

B