Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) › 2017.12–2018.04
RM33A0E _58 Vehicle Interior _065387 HEATING / AIR CONDITIONING _0341905 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) U

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY


E334599N10
5.063,0.313 5.479,0.583 0.417,0.271 3.875,0.313 4.292,0.583 0.417,0.271 2.479,0.313 2.896,0.583 0.417,0.271 5.198,0.365 5.542,0.583 0.344,0.219 10 false z8 3.969,0.354 4.313,0.573 0.344,0.219 10 false K54 2.573,0.354 2.917,0.573 0.344,0.219 10 false K55

HINT:

Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
K55-2 (SG-2) - Body ground W - Body ground Ground for thermistor assembly Always Below 1 V
K55-3 (SG-4) - Body ground L - Body ground Ground for air conditioner pressure sensor Always Below 1 V
K55-6 (S5-3) - K55-3 (SG-4) GR - L Power supply for air conditioner pressure sensor Ignition switch ON 4.75 to 5.25 V
Ignition switch off Below 1 V
K55-13 (TAM) - K55-2 (SG-2) R - W Thermistor assembly signal
·

Ignition switch ON

·

Ambient temperature: 25°C (77°F)


1.05 to 1.45 V
·

Ignition switch ON

·

Ambient temperature: 40°C (104°F)


0.64 to 0.87 V
K55-24 (PRE) - K55-3 (SG-4) W - L Air conditioner pressure sensor signal
·

Engine running

·

Air conditioning system operating

·

Refrigerant pressure: Abnormal pressure (more than 3.025 MPaG (30.8 kgf/cm2, 439 psi))


4.61 V or higher
·

Engine running

·

Air conditioning system operating

·

Refrigerant pressure: Abnormal pressure (less than 0.176 MPaG (1.8 kgf/cm2, 26 psi))


Below 0.74 V
·

Engine running

·

Air conditioning system operating

·

Refrigerant pressure: Normal pressure (less than 3.025 MPaG (30.8 kgf/cm2, 439 psi) and more than 0.176 MPaG (1.8 kgf/cm2, 26 psi))


0.74 to 4.61 V
K54-1 (B) - K54-4 (GND) LA-B - W-B Power source (Back-up) Always 11 to 14 V
K54-2 (IG+) - K54-4 (GND) LA-GR - W-B Power source (IG) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
K54-3 (SOL+) - K54-4 (GND) R - W-B Compressor solenoid operation signal
·

Engine running

·

Blower switch: LO

·

A/C switch: On


Pulse generation
(See waveform 1)
K54-4 (GND) - Body ground W-B - Body ground Ground for main power supply Always Below 1 V
K54-6 (BLW) - K54-4 (GND) LG - W-B Blower motor speed control signal
·

Ignition switch ON

·

Blower switch: LO


Pulse generation
(See waveform 2)
K54-11 (CANH) - K54-12 (CANL) SB - W CAN communication system CAN communication is performed Pulse generation
K54-14 (LIN1) - K54-4 (GND) BE - W-B LIN communication signal Ignition switch ON Pulse generation
(See waveform 3)
z8-2 (1A) - Body ground - Ground for BUS IC Always Below 1 V
z8-3 (2A) - z8-2 (1A) - BUS IC control signal Ignition switch ON Pulse generation
(See waveform 4)
z8-4 (3A) - z8-2 (1A) - Power supply for BUS IC Ignition switch off 11 to 14 V
z8-5 (4A) - Body ground GR - Body ground Ground for No. 1 cooler thermistor Always Below 1 V
z8-6 (5A) - z8-5 (4A) GR - GR No. 1 cooler thermistor signal
·

Ignition switch ON

·

Evaporator temperature: 0°C (32°F)


1.7 to 2.1 V
·

Ignition switch ON

·

Evaporator temperature: 15°C (59°F)


0.9 to 1.3 V

a.
E145424N07
2.979,1.271 3.354,1.438 0.375,0.167 10 false GND

Waveform 1:

Item Content
Terminal No. K54-3 (SOL+) - K54-4 (GND)
Tool Setting 5 V/DIV., 500 μs./DIV.
Condition
·

Engine running

·

Blower switch: LO

·

A/C switch: On




b.
E338778N01
2.823,1.24 3.281,1.438 0.458,0.198 10 false GND

Waveform 2:

Item Content
Terminal No. K54-6 (BLW) - K54-4 (GND)
Tool Setting 2 V/DIV., 1 ms./DIV.
Condition
·

Ignition switch ON

·

Blower switch: LO




c.
E334619N02
0.313,1.563 0.771,1.76 0.458,0.198 10 false GND

Waveform 3:

Item Content
Terminal No. K54-14 (LIN1) - K54-4 (GND)
Tool Setting 2 V/DIV., 20 ms./DIV.
Condition Ignition switch ON


d.
E202803N05
0.333,1.469 0.75,1.646 0.417,0.177 10 GND

Waveform 4:

Item Content
Terminal No. z8-3 (2A) - z8-2 (1A)
Tool Setting 2 V/DIV., 2 ms./DIV.
Condition Ignition switch ON



CHECK AIR CONDITIONING CONTROL ASSEMBLY


E368074E02
3.375,0.208 3.75,0.427 0.375,0.219 3.427,0.229 3.885,0.427 0.458,0.198 10 false K26

HINT:

Check from the rear of the connector while it is connected to the air conditioning control assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
K26-2 (IG+) - K26-6 (GND) GR - W-B Power source (IG) Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
K26-6 (GND) - Body ground W-B - Body ground Ground for air conditioning control assembly Always Below 1 V
K26-9 (LIN1) - Body ground LG - Body ground LIN communication signal Ignition switch ON Pulse generation
(See waveform)
K26-11 (ILL+) - Body ground W - Body ground Illumination signal Light control switch in off position Below 1 V
Light control switch in tail or head position 11 to 14 V
K26-15 (ILL-) - Body ground B - Body ground Illumination signal Always Below 1 V

a.
E202803N05
0.333,1.469 0.75,1.646 0.417,0.177 10 GND

Waveform:

Item Content
Terminal No. K26-9 (LIN1) - Body ground
Tool Setting 2 V/DIV., 20 ms./DIV.
Condition Ignition switch ON