The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat cushion heater assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT SEAT ASSEMBLY
71074S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
72495
3.REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)
72552B
4.REMOVE RECLINING HINGE COVER
72526
5.REMOVE RECLINING ADJUSTER RELEASE HANDLE
71849
6.REMOVE SEAT ADJUSTER COVER CAP (w/ Vertical Adjuster)
71811D
7.REMOVE FRONT SEAT CUSHION SHIELD (w/o Vertical Adjuster)
71861
8.REMOVE FRONT SEAT INNER CUSHION SHIELD (w/o Vertical Adjuster)
71812D
9.REMOVE FRONT SEAT CUSHION SHIELD (w/ Vertical Adjuster)
71862
10.REMOVE FRONT SEAT INNER CUSHION SHIELD (w/ Vertical Adjuster)
11.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
12.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
71071S
13.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
87510L
14.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY
Remove the 35 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.