84390B
1.INSPECT COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) (for LHD)
Inspect the NORMAL mode switch:
| *a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 13 (B) - 16 (GND1) | NORMAL mode switch being pushed and held | Below 1 Ω |
| NORMAL mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the combination switch (electric parking brake switch assembly).
Inspect the SPORT mode switch:
| *a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 12 (P) - 16 (GND1) | SPORT mode switch being pushed and held | Below 1 Ω |
| SPORT mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the combination switch (electric parking brake switch assembly).
Inspect the illumination:
| *a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) |
Apply battery voltage to the combination switch (electric parking brake switch assembly) and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 7 (ILL-) |
Illuminates |
If the result is not as specified, replace the combination switch (electric parking brake switch assembly).
84390B
2.INSPECT COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) (for RHD)
Inspect the NORMAL mode switch:
| *a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 12 (B) - 9 (GND1) | NORMAL mode switch being pushed and held | Below 1 Ω |
| NORMAL mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the combination switch (electric parking brake switch assembly).
Inspect the SPORT mode switch:
| *a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 13 (P) - 9 (GND1) | SPORT mode switch being pushed and held | Below 1 Ω |
| SPORT mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the combination switch (electric parking brake switch assembly).
Inspect the illumination:
| *a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) |
Apply battery voltage to the combination switch (electric parking brake switch assembly) and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 6 (ILL+)
Battery negative (-) → Terminal 2 (ILL-) |
Illuminates |
If the result is not as specified, replace the combination switch (electric parking brake switch assembly).