The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly (TWC: Rear Catalyst), center exhaust pipe assembly and tail exhaust pipe assembly removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
17430
1.REMOVE TAIL EXHAUST PIPE ASSEMBLY
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the 2 bolts and disconnect the tail exhaust pipe assembly from the center exhaust pipe assembly.
Remove the tail exhaust pipe assembly from the 2 exhaust pipe supports.
Remove the gasket from the center exhaust pipe assembly.
17420
2.REMOVE CENTER EXHAUST PIPE ASSEMBLY
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the 2 bolts and disconnect the center exhaust pipe assembly from the front exhaust pipe assembly (TWC: Rear Catalyst).
Remove the center exhaust pipe assembly from the exhaust pipe support.
Remove the gasket from the front exhaust pipe assembly (TWC: Rear Catalyst).
58166A
3.REMOVE FRONT FLOOR COVER LH
Remove the 3 bolts and 4 clips (A).
Disengage the grommet (B) and 6 clips (C) to remove the front floor cover LH.
58165C
4.REMOVE FRONT FLOOR COVER RH
Remove the 3 bolts and 4 clips (A).
Disengage the grommet (B) and 6 clips (C) to remove the front floor cover RH.
57533B
5.REMOVE FRONT CENTER FLOOR BRACE
Remove the 4 bolts and front center floor brace from the vehicle body.
57523A
6.REMOVE CENTER FLOOR CROSSMEMBER BRACE
Remove the 4 bolts and center floor crossmember brace from the vehicle body.
89467C
7.REMOVE AIR FUEL RATIO SENSOR (for Sensor 2)
17410
8.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Remove the 2 nuts and disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold (TWC: Front Catalyst).
Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the 2 exhaust pipe supports.
Remove the gasket from the front exhaust pipe assembly (TWC: Rear Catalyst).
17408
9.REMOVE TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY
Perform this procedure only when replacement of the tail exhaust pipe baffle sub-assembly is necessary.
If the tail exhaust pipe baffle sub-assembly is removed, replace it with a new one.
Type A (w/ Tail Exhaust Pipe Baffle):
Remove the tail exhaust pipe baffle sub-assembly.
Type B:
Remove the tail exhaust pipe baffle sub-assembly.