Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2017.12–2021.02
RM33A0E _58 Vehicle Interior _065384 PRE-COLLISION _0319645 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  C1A69  Brake Control Signal Mismatch  


DESCRIPTION

The skid control ECU (brake actuator assembly) sends signals to the millimeter wave radar sensor assembly according to the brake control status. If the millimeter wave radar sensor assembly receives a vehicle stability control system malfunction signal from the skid control ECU (brake actuator assembly), it will store DTC C1A69.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A69 Brake Control Signal Mismatch While the ignition switch is ON, the millimeter wave radar sensor assembly receives a vehicle stability control system malfunction signal from the skid control ECU (brake actuator assembly) for 1 second or more.
·

Vehicle stability control system

·

Millimeter wave radar sensor assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the millimeter wave radar sensor assembly has been replaced, be sure to perform millimeter wave radar sensor assembly adjustment.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT

·

The pre-collision system uses the CAN communication system. First, confirm that there are no malfunctions in the CAN communication system. Refer to How to Proceed with Troubleshooting.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.CHECK FOR DTCs (VEHICLE STABILITY CONTROL SYSTEM)
HINT:

Pre-collision system DTC C1A69 may be stored due to a malfunction in the vehicle stability control system. Therefore, it is necessary to check for and troubleshoot vehicle stability control system DTCs first.


a.

Check for DTCs.

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105

Result:
Result Proceed to
Vehicle stability control system DTCs are not output A
Vehicle stability control system DTCs are output B



A

2.CHECK FOR DTCs (PRE-COLLISION SYSTEM)

B

2.CHECK FOR DTCs (PRE-COLLISION SYSTEM)
a.

Clear the DTCs.

Body Electrical > Pre-Collision 2 > Clear DTCs
50002 220

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the ignition switch to ON and wait 1 second or more.




c.

Check for DTCs.

Body Electrical > Pre-Collision 2 > Trouble Codes
50001 220

Result:
Result Proceed to
DTC C1A69 is not output A
DTC C1A69 is output B



A

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY