When a malfunction is detected between various ECUs and sensors, these DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | After the ignition switch is turned to ON for 3 seconds or more, when the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the ECM and forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
ECM ·
Forward recognition camera |
| U0123 | Lost Communication with Yaw Rate Sensor Module | After the ignition switch is turned to ON for 3 seconds or more, when the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the yaw rate sensor (airbag sensor assembly) and forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Yaw rate sensor (Airbag sensor assembly) ·
Forward recognition camera |
| U0126 | Lost Communication with Steering Angle Sensor Module | After the ignition switch is turned to ON for 3 seconds or more, a communication error between the steering sensor and forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Steering sensor ·
Forward recognition camera |
| U0129 | Lost Communication with Brake System Control Module | After the ignition switch is turned to ON for 3 seconds or more, a communication error between the skid control ECU (brake actuator assembly) and forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Skid control ECU (Brake actuator assembly) ·
Forward recognition camera |
| U0131 | Lost Communication with Power Steering Control Module | After the ignition switch is turned to ON for 3 seconds or more, when the vehicle is being driven at a speed of 5 km/h (4 mph) or more, a communication error between the power steering ECU (rack and pinion power steering gear assembly) and forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Power steering ECU (Rack and pinion power steering gear assembly) ·
Forward recognition camera |
| U0142 | Lost Communication with Body Control Module "B" | After the ignition switch is turned to ON for 3 seconds or more, a communication error between the main body ECU (multiplex network body ECU) and forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Main body ECU (Multiplex network body ECU) ·
Forward recognition camera |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC) Control Module (Combination Meter) | After the ignition switch is turned to ON for 3 seconds or more, a communication error between the combination meter assembly and forward recognition camera is detected for approximately 50 seconds or more. | ·
CAN communication system ·
Combination meter assembly ·
Forward recognition camera |
Clear the DTCs.
Perform the following procedure.
If the following procedure is not performed, the previously output DTC cannot be detected.
Turn the ignition switch to ON and wait 1 minute or more.
Drive the vehicle at a speed of 5 km/h (4 mph) or more for 5 seconds or more.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U0100, U0123, U0126, U0129, U0131, U0142 and U0155 are not output | A |
| DTC U0100, U0123, U0126, U0129, U0131, U0142 or U0155 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING