This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
19100P
1.INSTALL SPARK PLUG
19500
2.INSTALL IGNITION COIL ASSEMBLY
Perform "Inspection After Repair" after replacing an ignition coil assembly.
w/ Canister Pump Module
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module
Using an 8 mm socket wrench, install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.
If an ignition coil assembly has been struck or dropped, replace it.
Install the same parts to their original positions.
Connect the 4 ignition coil assembly connectors.
12601B
3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
4.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
w/ Canister Pump Module
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
w/o Canister Pump Module