Home › Engine / Hybrid System › A25A-FKS (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1) › from 2017.12
RM33A0E _51 Engine / Hybrid System _065341 A25A-FKS ENGINE CONTROL _0328602 AIR FUEL RATIO SENSOR(for Sensor 1) A

A25A-FKS ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.



a.
A402381C01
2.5,0.844 2.063,0.844 true 1.406,0.646 1.646,0.844 0.24,0.198 10 true *a 2.542,0.75 3,0.948 0.458,0.198 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold (TWC: Front Catalyst).

SST
09224-00012  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.
A403618C01
2.875,0.708 2.521,0.802 2.521,0.802 2.646,0.365 true 3.052,0.229 2.938,0.229 2.938,0.229 2.844,0.427 true 3.083,0.125 3.313,0.323 0.229,0.198 10 true *a 2.448,0.823 2.677,1.031 0.229,0.208 10 true *b
*a Tie Band
*b Wire Harness Clamp


Connect the air fuel ratio sensor connector.


c.

Engage the 3 wire harness clamps so that the tie band is positioned as shown in the illustration.


Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the air fuel ratio sensor.