Home › Engine / Hybrid System › A25A-FKS (EMISSION CONTROL) › EGR COOLER › 2017.12–2020.08
RM33A0E _51 Engine / Hybrid System _065344 A25A-FKS EMISSION CONTROL _0328567 EGR COOLER A

A25A-FKS EMISSION CONTROL  EGR COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 25680 4.REMOVE EGR COOLER ASSEMBLY

a.
A430163C01
0.896,1.479 0.896,1.313 0.896,1.313 1.292,1.042 true 2.104,1.188 2.542,1.188 true 2.573,1.094 2.781,1.281 0.208,0.188 10 true *1 0.823,1.49 1.021,1.698 0.198,0.208 10 true *2
*1 No. 3 Water By-pass Hose
*2 No. 4 Water By-pass Hose


Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the EGR cooler assembly.


b.
A402222

Remove the 5 bolts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.


c.
A402224

Remove the EGR valve gasket from the EGR valve assembly.


d.
A402223

Remove the EGR cooler gasket from the EGR cooler assembly.