Home › Engine / Hybrid System › A25A-FKS (FUEL) › FUEL PRESSURE SENSOR (for High Pressure) › from 2017.12
RM33A0E _51 Engine / Hybrid System _065343 A25A-FKS FUEL _0319397 FUEL PRESSURE SENSOR(for High Pressure) A

A25A-FKS FUEL  FUEL PRESSURE SENSOR(for High Pressure)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89458 1.INSTALL FUEL PRESSURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the fuel pressure sensor.



a.
A401685C01
0.667,0.438 0.823,0.438 0.823,0.438 1.031,0.74 true 2.229,0.396 2.073,0.396 2.073,0.396 1.833,0.844 true 0.49,0.354 0.667,0.5 0.177,0.146 10 true *a 2.271,0.323 2.448,0.49 0.177,0.167 10 true *b
*a Cutout (Fuel Delivery Pipe)
*b Cutout (Fuel Pressure Sensor)


Temporarily install a new fuel pressure sensor to the fuel delivery pipe as shown in the illustration.

NOTICE:

Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.



b.
A401686C01
0.771,0.417 0.906,0.417 0.906,0.417 1.156,0.792 true 2.635,0.49 2.458,0.49 2.458,0.49 2.219,0.844 true 0.594,0.333 0.76,0.479 0.167,0.146 10 true *a 2.667,0.417 2.854,0.563 0.188,0.146 10 true *b
*a Cutout (Fuel Pressure Sensor)
*b Cutout (No. 1 Fuel Pressure Sensor Holder)


Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe as shown in the illustration.

NOTICE:

Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.



c.

Using an 8 mm socket wrench, install the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Connect the fuel pressure sensor connector.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 5.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the fuel pressure sensor.