Home › Vehicle Interior › SEAT › REAR SEAT ASSEMBLY (for Reclining Seat Type) › 2018.04–2021.02
RM33A0E _58 Vehicle Interior _065385 SEAT _0327859 REAR SEAT ASSEMBLY(for Reclining Seat Type) A

SEAT  REAR SEAT ASSEMBLY(for Reclining Seat Type)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during rear seat assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION



PROCEDURE

Hide 1. PRECAUTION (w/ Rear Seat Side Airbag)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag)

for 2AR-FE:

Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>REMOVAL

for A25A-FKS:

Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL

for 2GR-FKS:

Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>REMOVAL

for 6AR-FSE:

Click hereGeneral>MAINTENANCE>6AR-FSE BATTERY>REMOVAL

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If an airbag deploys for any reason, it may cause a serious injury.



Hide 71940A 3.REMOVE REAR SEAT HEADREST ASSEMBLY

a.

Remove the rear seat headrest assembly.

HINT:

Use the same procedure for the RH side and LH side.



Hide 71960B 4.REMOVE REAR CENTER SEAT HEADREST ASSEMBLY

a.

Remove the rear center seat headrest assembly.


Hide 73350C 5.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

a.
B488971C01
2.885,1.156 2.719,0.948 true 2.917,1.094 3.167,1.313 0.25,0.219 10 false *a
*a Protective Tape
V113146

Insert Screwdriver Here
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, disconnect the rear center seat outer belt assembly as shown in the illustration.


Hide 6.REMOVE REAR SEAT CUSHION ASSEMBLY

a.
B488973C01
0.417,1.406 0.667,1.156 true 1.365,0.219 1.177,0.375 true 2.615,0.375 2.427,0.531 true 2.208,1.552 2.354,1.865 true 0.219,1.344 0.406,1.552 0.188,0.208 10 true *a 1.385,0.115 1.594,0.313 0.208,0.198 10 true *b 2.625,0.281 2.833,0.479 0.208,0.198 10 true *b 2.375,1.781 2.604,1.99 0.229,0.208 10 true *a 0.896,2.448 1.094,2.646 0.198,0.198 10 false A 1.906,2.521 2.104,2.719 0.198,0.198 10 false A
*a Rear Seat Cushion Frame Hook (Front Side)
*b Rear Seat Cushion Frame Hook (Rear Side)
V113146

Place Hand Here
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Lift the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the rear seat cushion lock hooks.

NOTICE:

Be sure to hold the parts of the rear seat cushion assembly directly next to the rear seat cushion frame hooks when lifting it. Lifting a different part of the rear seat cushion assembly may deform the rear seat cushion frame.


Standard Measurement:
Area Measurement
A 245 mm (9.64 in.)



b.

Disengage the 2 rear seat cushion frame hooks on the rear side of the rear seat cushion assembly as shown in the illustration and remove the rear seat cushion assembly.

NOTICE:

Be careful not to damage the vehicle body.



c.

w/ Seat Heater System:

i.

Disconnect each connector.



Hide 72693 7.REMOVE REAR SEAT CUSHION LOCK HOOK

a.
B470026C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



Hide 72996A 8.REMOVE REAR SEATBACK COVER

a.
B488977

Disengage the 4 claws and remove the 2 rear seatback covers from the rear seatback assembly LH.

HINT:

Use the same procedure for the RH side and the LH side.



Hide 9.REMOVE REAR SEATBACK ASSEMBLY LH

a.

Disconnect the rear seat outer belt assembly LH from the rear seat shoulder belt guide LH.


b.
B488980

Disengage the 2 hooks and disconnect the cover from the package tray trim panel assembly.


c.
B488978C01
0,0 0,0 false
V100135

Nut
V100136

Bolt


Remove the 2 nuts, 2 bolts and rear seatback assembly LH.


d.

w/ Seat Heater System:

i.

Disconnect the connector.


ii.

Disengage the clamp.



Hide 10.REMOVE REAR SEATBACK ASSEMBLY RH

a.

Disconnect each rear seat outer belt from the rear seat shoulder belt guide RH and rear seat center shoulder belt guide.


b.
B488981

Disengage the 2 hooks and disconnect the cover from the package tray trim panel assembly.


c.
B488979C01
0,0 0,0 false
V100135

Nut
V100136

Bolt


Remove the 2 nuts, 2 bolts and rear seatback assembly RH.


d.

w/ Seat Heater System:

i.

Disengage the clamp.



Hide 11.REMOVE CENTER SEATBACK ASSEMBLY

a.

Disconnect the connector.


b.
B488982C01
1.938,1.115 2.594,1.115 true 0.781,2.729 1.073,2.51 true 2.615,2.51 2.885,2.719 true 0.583,2.635 0.781,2.844 0.198,0.208 10 true *a 2.604,1.031 2.823,1.219 0.219,0.188 10 true *b 2.906,2.646 3.104,2.854 0.198,0.208 10 true *a
V113147

Remove in this Direction


Remove the 2 bolts.


c.

Disengage the 2 guides.


d.

Disengage the hook and remove the center seatback assembly as shown in the illustration.


Hide 62332A 12.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.

Disconnect the rear door opening trim weatherstrip LH.


Hide 13.REMOVE REAR SIDE SEATBACK ASSEMBLY LH

a.

w/ Rear Seat Side Airbag:

i.

Disconnect the connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


1.
B474821C04
1.75,1.083 2.333,1.083 true 1.948,1.385 2.531,1.385 false 1.052,1.417 1.635,1.417 true 2.375,0.99 2.688,1.146 0.313,0.156 10 false *a 2.563,1.313 2.875,1.469 0.313,0.156 10 false *b 0.927,1.333 1.104,1.521 0.177,0.188 10 false A
*a White Housing Lock
*b Yellow CPA
V113147

Slide in this Direction


Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

2.

Push down the white housing lock again and disconnect the connector.

NOTICE:

Do not push down the part (A) shown in the illustration when disconnecting the connector.





b.
B488984

Remove the bolt.


c.

Disengage the hook and remove the rear side seatback assembly LH.

NOTICE:

Be careful not to damage the vehicle body.



Hide 62331A 14.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.


Hide 15.REMOVE REAR SIDE SEATBACK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.