Home › Drivetrain › U761E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM › 2018.04–2021.02
RM33A0E _52 Drivetrain _072210 U761E AUTOMATIC TRANSMISSION / TRANSAXLE _0351183 AUTOMATIC TRANSAXLE SYSTEM D

U761E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MANUAL SHIFTING TEST  


PERFORM MANUAL SHIFTING TEST


HINT:
·

Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

·

If any abnormalities are found in the following test, the problem is in the transaxle itself.



a.
C370672

Disconnect the connector from the wiring harness connector.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the connector from the wiring harness connector. The gears can then be changed mechanically with the shift lever.



b.

Drive the vehicle with the wiring harness connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

Shift Lever Position Gear
P P
R R
D 3rd
No Shift (Gear will not change)


c.

Connect the connector to the wiring harness connector.


d.

Clear the DTCs.

Powertrain > Transmission > Clear DTCs
50002 373