Home › Vehicle Interior › SEAT › SEAT MEMORY SWITCH › from 2018.04
RM33A0E _58 Vehicle Interior _065385 SEAT _0329609 SEAT MEMORY SWITCH G

SEAT  SEAT MEMORY SWITCH  INSPECTION  


PROCEDURE

Hide 84927 1.INSPECT SEAT MEMORY SWITCH (DRIVER DOOR)

a.
B509423C03
1.333,0.667 1.333,0.333 false 1.917,0.667 1.917,0.333 false 2.5,0.667 2.5,0.333 false 1.333,2.104 1.333,1.771 false 1.896,2.104 1.896,1.771 false 2.469,2.104 2.469,1.771 false 0.396,0.188 0.771,0.427 0.375,0.24 12 false *A 0.375,1.719 0.75,1.958 0.375,0.24 12 false *B 1.25,0.135 1.563,0.333 0.313,0.198 10 false *a 1.25,1.583 1.563,1.781 0.313,0.198 10 false *a 1.854,0.135 2.167,0.333 0.313,0.198 10 false *b 2.417,0.135 2.729,0.333 0.313,0.198 10 false *c 1.813,1.594 2.125,1.792 0.313,0.198 10 false *b 2.396,1.583 2.708,1.781 0.313,0.198 10 false *c 0.521,3.167 0.833,3.365 0.313,0.198 10 false *d
*A for LHD
*B for RHD
*a SET Switch
*b M1 Switch
*c M2 Switch
*d Component without harness connected
(Seat Memory Switch (Driver Door))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

If the result is not as specified, replace the seat memory switch (driver door).

2 - 1 M1 switch pressed Below 1 Ω
1 switch not pressed 10 kΩ or higher
5 - 1 M2 switch pressed Below 1 Ω
2 switch not pressed 10 kΩ or higher
3 - 1 SET switch pressed Below 1 Ω
SET switch not pressed 10 kΩ or higher