Home › Steering › STEERING COLUMN › STEERING HEATER SWITCH › from 2018.04
RM33A0E _55 Steering _065371 STEERING COLUMN _0351222 STEERING HEATER SWITCH G

STEERING COLUMN  STEERING HEATER SWITCH  INSPECTION  


PROCEDURE

Hide 84255 1.INSPECT STEERING HEATER SWITCH

a.
C395230C01
2.052,1.427 2.25,1.906 true 1.198,1.906 1.375,1.427 true 1.573,1.927 1.604,1.427 true 0.094,0.063 0.406,0.26 0.313,0.198 10 false *a 1.135,1.927 1.448,2.125 0.313,0.198 10 false IG 1.542,1.958 1.854,2.156 0.313,0.198 10 false E 2.24,1.917 2.552,2.115 0.313,0.198 10 false B
*a Component without harness connected
(Steering Heater Switch)


Remove the steering heater switch.

Click hereSteering>STEERING COLUMN>STEERING HEATER SWITCH>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (IG) - 2 (B) Steering heater switch is pushed Below 1 Ω
5 (IG) - 2 (B) Steering heater switch is not pushed 10 kΩ or higher



c.

Indicator Inspection

i.

Apply battery voltage to the steering heater switch and check that the indicator illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 2 (B)
Battery negative (-) → Terminal 4 (E)
Illuminates