When the mirror heater switch (rear window defogger switch) on the radio and display receiver assembly*1 or air conditioning control assembly*2 is pressed, the operation signal is sent to the air conditioning amplifier assembly via CAN communication*1 or LIN communication*2. When the air conditioning amplifier assembly receives the signal, it turns on the DEF relay to operate the mirror heaters.
*1: for 8 Inch Display
*2: except 8 Inch Display
The power mirror control system (w/o Memory) uses the CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the power mirror control system (w/o Memory) after confirming that the communication systems are functioning properly.
Inspect the fuses for circuits related to this system before performing the following procedure.
If the battery voltage is low, the mirror heater function may not operate. In this case, check the Data List item "Battery Control Count (Body ECU)".
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Defogger Relay (Rear) | Mirror Heater | OFF or ON | - |
| Tester Display |
|---|
| Defogger Relay (Rear) |
| Result | Proceed to |
|---|---|
| Mirror heater operation on both mirrors is not normal | A |
| Mirror heater operation on RH side mirror is not normal | B |
| Mirror heater operation on LH side mirror is not normal | C |
A
B
C
Check the window defogger system operation.
Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>OPERATION CHECK
The window defogger system operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>WINDOW / GLASS>WINDOW DEFOGGER SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Remove the DEF relay from the engine room relay block and junction block assembly.
Disconnect the N19 outer rear view mirror assembly RH connector.
Disconnect the O16 outer rear view mirror assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| DEF relay holder terminal-3 - O16-2 (+) | Always | Below 1 Ω |
| DEF relay holder terminal-3 - N19-2 (+) | Always | Below 1 Ω |
| DEF relay holder terminal-3 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Remove the DEF relay from the engine room relay block and junction block assembly.
Disconnect the N19 outer rear view mirror assembly RH connector.
Disconnect the O16 outer rear view mirror assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| DEF relay holder terminal-3 - N19-2 (+) | Always | Below 1 Ω |
| N19-11 (E) - Body ground | Always | Below 1 Ω |
| N19-2 (+) - Body ground | Always | 10 kΩ or higher |
| DEF relay holder terminal-3 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer mirror RH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>REMOVAL
Inspect the outer mirror RH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>INSPECTION
Outer mirror RH is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the DEF relay from the engine room relay block and junction block assembly.
Disconnect the O16 outer rear view mirror assembly LH connector.
Disconnect the N19 outer rear view mirror assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| DEF relay holder terminal-3 - O16-2 (+) | Always | Below 1 Ω |
| O16-11 (E) - Body ground | Always | Below 1 Ω |
| O16-2 (+) - Body ground | Always | 10 kΩ or higher |
| DEF relay holder terminal-3 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the outer mirror LH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>REMOVAL
Inspect the outer mirror LH.
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>INSPECTION
Outer mirror LH is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG