These DTCs are stored if there is a malfunction in the CAN communication system connected to the television camera controller.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| U0073 | Control Module Communication Bus Off | Control module communication bus off | CAN communication system | Circumference Monitoring Camera Control Module |
| U0265 | Lost Communication with Image Processing Sensor A | Lost Communication with rear television camera assembly | CAN communication system | Circumference Monitoring Camera Control Module |
| U1110 | Lost Communication with Clearance Warning ECU | Lost communication with clearance warning ECU assembly | CAN communication system | Circumference Monitoring Camera Control Module |
Clear the DTCs.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| No DTCs are output | B |
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even if the DTC was not output when rechecking for DTCs.
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING